If the original install was with the EXE installer, then the file should be named "setup.msi". For upgrade, the streamer.msi file name has to be the same as the originally installed MSI file name.Msiexec /norestart /qn /i streamer.msi REINSTALL=ALL REINSTALLMODE=vomus MSIENFORCEUPGRADECOMPONENTRULES=1 CA_UPGRADE=1 USERINFO="hidewindow=1" Replace "streamer.msi" with the actual file name of your Streamer MSI installer.Msiexec /norestart /qn /i streamer.msi USERINFO="sc= gateway_address:port,dcode= your_code,hidewindow=1,confirm_d=0,ignoressl=1" sec_code= your_security_code: Choose the security code to use (no space or special symbols allowed).Ĭreate a custom configured MSI for GPO deployment:įor easier deployment via Group Policy (GPO), you can create a custom configured MSI to include several settings, such as the deployment code.(Note: the deployment code config overrides this parameter) hidewindow=1: Do not show the Streamer window after installation.ignoressl=1: Do not prompt SSL warning if the Gateway has no trusted SSL cert.confirm_d=0: Do not show the confirmation prompt when injecting deployment code.dcode= your_code: Inject the 12-digit deployment code to automatically associate the Streamer with pre-defined Splashtop group and settings.sc= gateway_address:port: the Gateway's IP/FQDN:Port, if Port is 443, it can be ignored./i: Run in command-line mode (required).Note that there is no space after each comma. Replace "your_code" with your own 12-digit deployment code.Replace "gateway_address:port" with your own gateway's IP/FQDN:Port.Replace "streamer.exe" with the actual file name of your streamer installer.Streamer.exe prevercheck /s /i hidewindow=1 Streamer.exe prevercheck /s /i sc= gateway_address:port,dcode= your_code,confirm_d=0,ignoressl=1,hidewindow=1 Notice: Supported by Splashtop Streamer 3.3.6.0 or higher.
Splashtop Streamer can be silently installed with command line parameters.